Make sure that the (blue) Wi-Fi lamp on the printer is also lit. When wireless connection is complete, the LED lights up for about 3 seconds, then changes to "1" as shown in the illustration below. The (blue) Wi-Fi lamp on the printer will flash while searching for, or connecting to the access point.ģ. Make sure that the LED flashes as shown in the illustration above, then press the button on your access point within 2 minutes.įor exact details regarding pressing the WPS button, please refer to the access point manual. Make sure that the LED flashes as shown in the illustration below.Ģ. Press and hold the button (A) on the printer for approximately 5 seconds.Ģ. If the power is on, the LED (Light Emitting Diode) is lit as shown in the illustration below.ġ. Most WPS enabled access points use this protocol. Your network must be using the WPA (Wi-Fi Protected Access) or WPA2 security protocol. If the WPS push button is not available please use the instructions in the Standard Connection Method section. Please check with your device’s user guide for details. The access point must have a physical WPS push button available. Before we start, there are some conditions that must be met in order to use the WPS push button method:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |